How to Build a Simple Bookshelf: Beginner Step-by-Step

Wooden bookshelf filled with books

A bookshelf is one of the best first furniture projects. It uses straight cuts, simple joints, and common boards, and you end up with something you will use every day. This guide shows you how to build a bookshelf about 36 inches tall and 30 inches wide using basic tools.

What You Will Need

Materials:

  • Two 1×10 pine boards, 8 feet long (actual size about 3/4 x 9-1/4 inches)
  • One sheet of 1/4 inch plywood, at least 30 x 36 inches, for the back
  • Wood glue
  • 1-1/4 inch wood screws or 1-1/4 inch pocket screws
  • 3/4 inch brad nails or small screws for the back
  • Sandpaper (120 and 180 grit), and paint or stain
  • A furniture anti-tip kit

Tools: tape measure, speed square, circular saw or miter saw, drill/driver, clamps, and optionally a pocket-hole jig.

Cut List

  • Sides: 2 pieces at 36 inches
  • Shelves (top, bottom, and two middle): 4 pieces at 28-1/2 inches
  • Back: 1 piece of plywood at 30 x 36 inches

The shelves are 28-1/2 inches because the two sides add 1-1/2 inches, giving an overall width of 30 inches. Keeping shelf spans around 30 inches or less helps 3/4 inch pine resist sagging under books.

Step-by-Step Instructions

  1. Cut and sand. Cut all pieces, then sand the faces with 120 grit and the edges until smooth.
  2. Mark the shelf positions. Lay the two sides next to each other and mark the shelf locations on both at the same time so they match. A good layout is the bottom shelf 2 inches up from the floor, the top flush with the top, and the two middle shelves evenly spaced.
  3. Drill pocket holes or pilot holes. If you have a pocket-hole jig, drill two or three holes in each shelf end. Otherwise, you will screw through the sides into the shelf ends, so pre-drill to prevent splitting.
  4. Assemble the box. Apply glue to a shelf end, clamp it to the side at your mark, and drive the screws. Attach the top and bottom first, then the middle shelves.
  5. Square it up. Measure both diagonals of the frame. When they are equal, the case is square.
  6. Attach the back. Glue and nail the plywood back to the sides and shelves. The back holds the bookshelf square and stops it from racking side to side.
  7. Finish. Fill screw holes with wood filler, sand with 180 grit, and apply paint or stain and a clear topcoat.

Anchor It to the Wall

Any bookshelf can tip over, especially with children in the home. Use an anti-tip kit to secure the top of the bookshelf to a wall stud. It takes five minutes and is the most important step.

Make It Your Own

Once you have built one, it is easy to change the size. Keep the shelf length the same and make the sides taller for more shelves, or add a face frame for a more finished look.

New to the tools in this guide? Start with our list of basic tools for beginners. For more ready-made project designs with cut lists, read our overview of woodworking plans for beginners.

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *